Cartographer V4 - AIO - USB & CAN

Overview

Introducing the Cartographer Probe v4: The Ultimate Eddy Current Displacement Sensor for 3D Printers

THIS PROBE WORKS WITH BOTH USB and CAN SETUPS.

This probe will ship with both USB and CAN Cables and will be flashed with USB Firmware by default, you can change this to CAN easily

Cartographer V4 not only introduces a new All in One Design but improved thermal and electrical reliability.

* Although most components are rated up to 125oC, we do not recommend going above 110oC ambient temperature.

** Please note, our design is slightly different to our competitor's H variety, please check the CAD. V4 is compatible with a majority of Cartographer V3 mounts.

This latest version allows for you to switch between using either CAN or USB via Firmware, no need to re-solder anything.

CAN provides easy and simple wiring, no need to run multiple wires from your MCU, or use one of your limited number of USB ports, just tap into your Toolheads CAN output, and enjoy a seamless setup.

It is recommended to run your CAN network at a baud rate of 1,000,000.

with the probes proximity to your printer's nozzle, the adxl345 provides a higher level of accuracy when running input shaper than motor mounted alternatives.

Currently we do not support delta printers.

Take Your 3D Printing to the Next Level with Cartographer!

Highlights

• Faster and more powerful MCU Rated to 125oC*
• Simple and Reliable All in One Design**
• Increased Accuracy with refined coil routing and design
• Updated and Improved USB Cable
• No more bridging pads for DFU mode (we gave you holes)
• MCU: stm32g431
• Connectivity: CAN & USB via 4 pin Genuine Molex Sherlock connector.
• Firmware Requirement: Klipper
• 1 x Cartographer Probe V4
• 1 x 1.8m USB Cable (USB-A to Genuine Molex Sherlock)
• 1 x 18cm CAN Cable (DuPont to Genuine Molex Sherlock)
• 1 x Silicone Nozzle Brush